Operation Manual

180 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
Before you begin, you must have at least one on-demand WAN call
destination configured. Further, decide whether you want to use
NLSP or RIP/SAP as a routing protocol. AVM recommends that you
use RIP/SAP for connections over ISDN.
For RIP/SAP connections over ISDN, the Periodic Update Interval for IPX
RIP and SAP is automatically set to 10000 when you reinitialize your system!
What You Need
Procedure
Procedure
Note
To configure a routed on-demand call, complete the following steps:
1. Configure an ISDN Call Destination entry.
Parameter path: Select WAN Call Directory > Press <Ins> >
Specify a name for the call destination > Select a Wide Area
Medium.
Detailed information on configuring ISDN Call Destinations is
given in Chapter 7.
1a. Set the parameter Call Type to On Demand.
2. Configure IPX.
Parameter path: Select Protocols > Select IPX.
2a. Set Packet Forwarding to Enabled.
3. Bind IPX to an ISDN interface.
Parameter path: Select Bindings > Press <Ins> > Select IPX >
Select a configured ISDN interface or interface group.
3a. Press <Enter> on WAN Call Destinations, then press
<Ins>.
3b. Select a configured on-demand call destination from
the list.
3c. Set the WAN Call Type to Routed On Demand.
3d. Set the WAN Call Status to Enabled.
3e. Leave the defaults in Expert Options.
Ipx.pm6 27.05.97, 21:05180