Operation Manual

178 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
Before configuring permanent IPX connections decide whether you
want to use NLSP or RIP/SAP as a routing protocol. AVM recom-
mends that you use RIP/SAP for connections over ISDN.
For RIP/SAP connections over ISDN, the Periodic Update Interval for IPX
RIP and SAP is automatically set to 10000 when you reinitialize your system!
What You Need
Procedure
Procedure
Note
1. Configure an ISDN Call Destination entry.
Parameter path: Select WAN Call Directory > Press <Ins> >
Specify a name for the call destination > Select a Wide Area
Medium.
Detailed information on configuring ISDN Call Destinations is
given in Chapter 7.
1a. Set the parameter Call Type to Permanent.
1b. Set the Retry Mode to Retry All Failures.
1c. Set the Retry Limit Handling to Continuous At Limit.
1d. Set the Retry Interval Limit to 8 seconds.
2. Configure IPX.
Parameter path: Select Protocols > Select IPX.
2a. Set Packet Forwarding to Enabled.
3. Bind IPX to an ISDN interface.
Parameter path: Select Bindings > Press <Ins> > Select IPX >
Select a configured ISDN interface or interface group.
3a. Press <Enter> on WAN Call Destinations, then press
<Ins>.
3b. Select a configured permanent call destination from the
list.
3c. Set the WAN Call Type to Automatic.
Ipx.pm6 27.05.97, 21:05178