Operation Manual

Configuring IPX 169

Procedure

You configure manual IPX connections as follows:

1. Configure an ISDN Call Destination entry.

Parameter path: Select WAN Call Directory > Press <Ins> >

Specify a name for the call destination > Select a Wide Area

Medium.

Detailed information on configuring ISDN Call Destinations is

given in Chapter 7.

1a. Set the Call Type to On Demand.

2. Configure IPX.

Parameter path: Select Protocols > Select IPX.

2a. Set Packet Forwarding to Enabled.

3. Bind IPX to an ISDN interface.

Parameter path: Select Bindings > Press <Ins> > Select IPX >

Select a configured ISDN interface or interface group > Select

Expert Bind Options.

3a. If you chose NLSP with RIP/SAP Compatibility as Rout-

ing Protocol, select NLSP Bind Options and set the

NLSP State to Off.

4. Activate the configuration by using the Reinitialize System

command.

5. Load the Call Connection Manager utility and control your

IPX connections manually.

Procedure

Manual IPX Connections via Client Initiated Call Control

(CICC)

CICC is available for the following platforms:

♦ CICC for NetWare in the form of two NetWare Loadable

Modules

(NLMs

) is installed per default in the SYS:SYSTEM

directory.

Ipx.pm6 27.05.97, 21:05169