Operation Manual

168 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
Manual IPX Connections via CALLMGR
What You Need
4a. The Control State field should read Any Community May
Write or Specified Community May Write.
If it reads Specified Community May Write, note the name in
the Control Community field.
5. Activate the configuration on the local and the remote site
with the Reinitialize System command.
6. You then load STATICON and configure all static routes and
services on the routers at each end of the connection.
For information on configuring static routes and services with
STATICON, refer to the NetWare MultiProtocol Router 3.1 Configu-
ration guide, pp. 118 to 128.
STATICON configures all routes and services automatically on
each router and allows you to try the configuration before saving
it to disk. The STATICON configuration becomes active immedi-
ately; you do not need to reinitialize or restart the router.
The Call Connection Manager (CALLMGR.NLM) enables you to
initiate and terminate IPX connections over ISDN manually and to
monitor the status of an IPX connection.
Load CALLMGR by typing the following command at the server
prompt:
load callmgr <Enter>
Before configuring call destinations to use with CALLMGR, decide
whether you want to use NLSP or RIP/SAP as a routing protocol.
AVM recommends that you use RIP/SAP for connections over ISDN.
For RIP/SAP connections over ISDN, the Periodic Update Interval for IPX
RIP and SAP is automatically set to 10000 when you reinitialize your system!
Note
Ipx.pm6 27.05.97, 21:05168