Operation Manual

162 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
11. Select one of the options described above, then press
<Enter>.
12. If you selected Send Traps With Specified Community , enter
a name in the Trap Community field, then press <Enter>.
Enter the community name to be included in trap messages.
13. Select Other SNMP Parameters, then press <Enter>.
Enter other SNMP command-line parameters in the window that
is displayed, then press <Enter>.
The parameters should be entered in the same format they
would appear when entered on the LOAD SNMP command line.
14. When you are finished, press <Esc>; if prompted, select Yes
to save the changes to the SNMP parameters, then press
<Enter>.
The Manage Configuration menu is displayed.
15. Select Configure SNMP Information, then press <Enter>.
The General SNMP Information For This Node window is
displayed.
16. Select Node Name for SNMP, then press <Enter>.
Enter the name SNMP reports to the management client for this
node, then press <Esc>.
By convention, this is the IP hostname for the node. If the node
does not have an IP hostname, it is recommended that you use
the NetWare® file server name for this node.
17. Select Hardware Description, then press <Enter>.
Enter the hardware description for this node, then press <Esc>.
The hardware description can include the CPU type, bus speed,
size of memory, size and type of disks, printers, tape drives, and
so on. This description, combined with the information about the
software taken from the system, makes up the SNMP system
description.
18. Select Physical Location, then press <Enter>.
Enter the location description for this node, then press <Esc>.
Globalpa.pm6 27.05.97, 12:45162