Operation Manual

156 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
Enter the Day of Week, the Time of Day and the Minute of Hour you
want to have the NLM loaded and specify the Command Line for the
NLM.
When you are finished, press <Esc> and save your changes. The new
entry is now included in the list.
To return to the MPR for ISDN Global Configuration, press <Esc>.
ISDN Trap Propagation
Figure 8-3:
ISDN Trap Propagation Configuration
SNMP enables network management clients to exchange information
about the configuration and status of nodes on an internetwork. The
information available is defined by a set of managed objects referred
to as the Management Information Base (MIB).
To enable SNMP management on the NetWare MultiProtocol Router
for ISDN, you have to enable Trap propagation and configure SNMP
information. ISDN Trap Propagation is configured in the Global MPR
for ISDN Configuration. To configure SNMP information, refer to
section "Configuring SNMP Information" later in this Chapter.
The ISDN Trap Propagation command in the Global MPR for ISDN
Configuration lets you define whether ISDN Line Management Traps
and Traps reporting ISDN error causes 0x33 and 0x34 are sent to any
SNMP-based management console.
If you enable one of the parameters described below and the management
console is connected over ISDN, you have to disable the SNMP over IPX
Filter or SNMP over IP Filter, depending on which network protocol you want
to use for sending Traps. Otherwise, the Traps will be dropped at the ISDN
driver level.
Press <Enter> on ISDN Trap Propagation in the Global MPR for ISDN
Configuration to display the following menu:
Note
Globalpa.pm6 27.05.97, 12:45156