Operation Manual

150 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
Default: Stop At Limit
Options: Continuous At Limit, Stop At Limit
For connections with the Call Type set to Permanent (D64S, DS01
and DS02 connections, see Step 6 above), set this parameter to
Continuous At Limit.
47. Check the Retry Interval Limit .
Retry Interval Limit specifies the maximum delay interval (in
HH:MM:SS) between attempts to establish a connection. The
delay is set to about 8 seconds and increases exponentially.
48. Press <Esc> to return to the Internetworking Configuration
menu and save your changes when prompted.
Changing ISDN Call Destination Parameters
To change any parameter associated with an ISDN Call Destination,
complete the following steps:
1. At the server prompt, type
LOAD INETCFG <Enter>
The Internetworking Configuration menu is displayed.
2. From the Internetworking Configuration menu, select WAN
Call Directory , then press <Enter>.
A new window displays a list of the configured WAN Call
Destinations.
3. Highlight the desired ISDN Call Destination in the list, then
press <Enter>.
A new window displays the ISDN Call Destination parameters
for the selected interface.
4. Make new selections for the parameters that need to
change, then press <Esc>.
A new window prompts you to save the changes.