Operation Manual

144 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
If you set a value for the Channel Release Threshold, the
additional channel(s) is (are) disconnected when the load is
below the threshold over the Load Duration (see below).
When the Channel Release Threshold is set to 0%, the
additional channel(s) is (are) only deactivated when the
Inactivity Timeout expires.
34c. Specify the Load Duration .
The Load Duration defines the time during which the load
must match the Channel Allocate Threshold or the Channel
Release Threshold before additional channels are switched
through or disconnected.
35. Check Static Bundling .
Static Bundling specifies whether a specified number of data
channels is automatically bundled on an ISDN-Controller each
time a physical connection is set up to the current ISDN Call
Destination, thus increasing the bandwidth to a multiple of 64
Kbps, irrespective of the actual data traffic.
If you have more than one AVM ISDN-Controller installed and
configured on your router, refer to Step 36 below, "Multi-Control-
ler Bundling".
When two or more data channels are bundled, the connection charges
are of course multiplied by the number of data channels used. Please
keep this in mind when configuring this parameter.
If you want to use Static Bundling, the required data channels must be
available for this connection on the ISDN-Controller of both the local
and the remote site. For more information on this, refer to Chapter 14,
section "Static Bundling and Channel On Demand" in this Guide.
Default: Disabled
BRI: Options: Disabled, Enabled
PRI: Options: Disabled, 1 B Channel, 2 B Channels,
3 B Channels, ..., 15 B Channels
If Static Bundling is disabled, only one data channel is used to
establish an ISDN connection. The other data channel(s) avail-
able on the ISDN-Controller may be used separately by other
ISDN Call Destinations for the other interfaces.
Important
Note