Operation Manual

About This Guide 13
This guide is written for the network administrator responsible for
installing and configuring NetWare® software and NetWare®
MultiProtocol Router
TM
for ISDN 3.1 software. It is not intended to
provide detailed information about LAN media, WAN media, or
network protocols.
As the administrator, you must plan and implement the connection
of the router to the physical internetwork. This task involves laying
the network cables, installing network interface boards, installing
ISDN-Controllers, adding and removing nodes, and placing routers.
To perform these tasks, you should have technical knowledge of
protocols, network addressing, routing, and operational issues.
There are four basic steps to getting your NetWare MultiProtocol
Router for ISDN installed and operating on your network:
- First, install one or more AVM ISDN-Controllers.
- Second, upgrade to or install new NetWare 3.12 (or NetWare 4.1)
operating system software.
- Third, upgrade to or install the new NetWare MultiProtocol
Router 3.1 software.
- Fourth, configure the network interfaces and protocols, then bind
the appropriate protocols to the appropriate interfaces.
About This Guide
Chapter Summaries
This section briefly summarizes each chapter in this guide. Use these
summaries to help you locate specific topics, or to help you decide
which portions of this guide contain new information.
Chapter 1, "Introduction to NetWare MultiProtocol Router for ISDN
3.1," provides a detailed overview of the multiple features of the
product.
Aboutthi.pm6 27.05.97, 11:1413