Operation Manual

120 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
When configuring backup calls, the Call Type must also be set to
Permanent.
For detailed information on on-demand and permanent connec-
tions and classic and dynamic ISDN interface usage, refer to
Chapter 4, "Basic Design of ISDN-WANs and Configuration
Overview" in this Guide.
7. Specify an Interface Group or an Interface Name .
Specify the name of the interface or the interface group to initiate
an outbound connection. The Interface Name or Interface Group
is selected from a list of previously configured ISDN interfaces.
You can specify an Interface Name or an Interface Group, but not
both.
When you specify an Interface Name, this interface is always
used for outgoing and incoming calls to and from this destina-
tion. If the interface is already in use for a different connection,
the call set-up attempt fails.
When you specify an Interface Group, the system selects any
available interface associated with the group for in- and out-
bound connection attempts.
8. Specify the ISDN Number .
Enter the complete number to reach the remote site you want to
connect to.
Be sure that you enter the complete number. The complete
number to enter here depends on how the respective ISDN
device is connected to the public ISDN, on the location of the
remote site and how the addressed ISDN adapter/device there is
connected to the public ISDN. The ISDN Number of the remote
site can therefore maximally consist of the following "compo-
nents":
- PBX Outside Line Access (DO NOT FORGET !)
- International Dialing Prefix
- Country Code
- Area Code