Operation Manual

Configuring ISDN Call Destinations 117
The ISDN Call Destination name entered here is used in several
other menu options when an ISDN Call Destination name needs
to be identified. You should use a descriptive name, such as the
name of the remote destination and whether it is a LAN or a
remote node or a branch or store number.
3. Enter a name for the new ISDN Call Destination, then press
<Enter>.
A list of supported wide area media is displayed. These are
media available on previously configured ISDN interfaces. If you
have not yet configured such an interface, the respective medium
is not displayed in this list.
If you have not installed an ISDN-Controller and configured an interface
before attempting to configure an ISDN Call Destination, you receive
this message:
WAN network interfaces must be configured
before WAN Call Destinations may be created.
4. Select a Wide Area Medium and press <Enter>.
The wide area media listed depend on which version of the
NetWare MultiProtocol Router for ISDN 3.1 you have installled:
the BRI version (ISDN-BRI), the PRI version (ISDN-PRI), or both.
Select ISDN-BRI for AVM ISDN-Controllers for Basic Rate
Interfaces (BRI).
Select ISDN-PRI for AVM ISDN-Controllers for Primary Rate
Interfaces (PRI).
The ISDN Call Destination Configuration menu is displayed:
Note