Operation Manual

116 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
Configuring an ISDN Call Destination
Special configuration scenarios are described in the following chap-
ters of this Guide:
- Chapter 9, "Configuring IPX"
- Chapter 10, "Configuring TCP/IP"
- Chapter 11, "Configuring AppleTalk"
- Chapter 12, "Configuring Source Route Bridge"
- Chapter 13, "Advanced Configuration"
- Chapter 14, "Configuration Interdependencies"
- Chapter 15, "Configuring Remote Node Access"
This chapter contains the following sections:
- "Configuring an ISDN Call Destination" on page 116
- "Changing ISDN Call Destination Parameters" on page 150
- "Deleting an ISDN Call Destination" on page 151
To configure ISDN Call Destinations, INETCFG is required. If
INETCFG is not already loaded, load it by typing the following
command at the server prompt:
LOAD INETCFG <Enter>
The Internetworking Configuration menu is displayed.
Proceed as follows:
1. From the Internetworking Configuration menu, select WAN
Call Directory , then press <Enter>.
The Configured WAN Call Destinations window is displayed. This
window has no entries if no ISDN Call Destinations are config-
ured.
2. Press <Ins> to configure a new ISDN Call Destination.
The prompt New Call Destination Name: allows you to enter a
name of up to 47 alphanumeric characters for the new ISDN Call
Destination.
Procedure