Operation Manual

Configuring ISDN Interfaces 111
the network protocol. In addition, the call is visible in the ISDN
Console (Remote Nodes).
- You should set the Disconnect Timeout to an appropriate value to
make sure that connections to unknown remote sites are
disconnected after a specified period of inactivity. Example: On
AVM´s Data Call Center, the Disconnect Timeout is set to 5 min.
- To make sure that unknown remote sites are not allowed to use
channel bundling, it is recommended to leave the defaults
Channel On Demand=Disabled and Static Bundling=Disabled.
ISDN-Controller Configuration
In the ISDN-Controller Configuration you define special parameters
that apply for the current ISDN-Controller.
You only have to enter this menu, if
- You have a point-to-point ISDN access.
- You want to accept all incoming calls on this ISDN-Controller as
Mobile ISDN calls only.
- You have to use SPIDs (D channel protocols NI-1 and 5ESS).
- You are using an AVM ISDN-Controller for PRI.
For each ISDN-Controller, you have to configure these parameters only
once!
Changes in the ISDN-Controller Configuration are brought into effect
by selecting the Reinitialize System command from the Internetworking
Configuration menu. The boards are unloaded and reloaded again
with the new settings.
When you press <Enter> on ISDN-Controller Configuration in the
ISDN Network Interface Configuration menu, the following menu is
displayed:
Figure 6-7:
ISDN-Controller Configuration menu
Important