Operation Manual

110 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
Figure 6-8:
Default Call Destination Configuration for ISDN Interface <Interface Name> menu
Check all the values in this menu. For detailed information on each of
the parameters, refer to Chapter 7, "Configuring ISDN Call Destina-
tions".
Note the following differences to the ISDN Call Destination
Configuration:
- Encapsulation Protocol:
the default value is Auto-Framing to allow automatic detection of
the protocol used (AVM Proprietary or PPP over ISDN).
- COSO:
the option "Local" is not available, since it would not make sense
to assume the charges for an unknown caller.
- PPP Destination Type:
this parameter defines how PPP calls from "unknown" sites are
accepted. Options are "LAN" and "Remote-Node".
LAN means that for incoming PPP calls, parameters are
negotiated as defined in RFC 1634 (IPXWAN). In addition, the call
is visible through the Call Connection Manager (CALLMGR).
If you select Remote-Node, parameters will be negotiated as
defined in RFC 1552 (IPXCP) or RFC 1332 (IPCP), depending on