Operation Manual

108 NetWare MultiProtocol Router for ISDN 3.1 Installation and ISDN Configuration Guide
Default: 0 (= disabled)
Options: 0 to 2000 (milliseconds)
13. For international connections, enter the Dialing Suffix .
For certain international connections, a special character is
needed to indicate the end of the phone number. This will
accelerate call set-up considerably from within about 12 to 15
seconds to 1 to 2 seconds.
Enter the required symbol in this place to accelerate call-set up to
abroad sites.
Example: For connections from Belgium to Germany, the
character to enter is #.
14. Check the Statistics Period .
This parameter specifies the rate (in seconds) at which the ISDN-
controller updates the statistics gathered.
Default: 30
Range: 5, 6, 7 ... 300
These Statistics can be viewed through the ISDN Console or via
the MPR for ISDN Router Manager or any SNMP-based manage-
ment console by displaying the specified tables as described in
MPR4ISDN.MIB.
15. Check the Starvation Timeout .
This parameter defines the period of time the NetWare MultiPro-
tocol Router for ISDN will wait for replies from remote sites.
When a data channel is broken, a signal is sent over the D chan-
nel to report the event. Since there is no D channel in D64S lines,
this parameter is mainly used with D64S. However, it also
applies for other ISDN lines.
Default: 10 (seconds)
Options: 0 to 30 seconds (0=disabled)
16. Check the Queue Limit .
This parameter specifies the maximum number of outbound
data packets that can be queued within the NetWare operating
system and on the ISDN-Controller to this interface for transmis-
sion. When the limit is exceeded, subsequent outbound data