Operation Manual

Configuring ISDN Interfaces 103
Code, Area Code, ISDN Number, PBX Outside Line Access and
PBX Extension) of the remote site or the Dial-Back Number, if
configured.
With Force Call-Back to CLI Number, the NetWare MultiProtocol
Router for ISDN dials back the number delivered over the D
channel of the ISDN network.
6. Check the Number of Retries .
This parameter specifies the number of retries the ISDN-Control-
ler will initiate an attempt to establish an ISDN connection.
Default: 3
Range: 0, 1, 2, 3, ... 10 (0=no retry)
If the ISDN network message "Network Congestion" is returned very
often (esp. for international calls), you should enter a higher value for
this parameter to compensate for short-term congestions in the ISDN
network.
7. Check the Pause Between Retries .
This field specifies the pause (in seconds) between two attempts
to establish an ISDN connection.
Default: 3
Range: 1, 2, 3, ... 30
8. Check the Inbound Call Processing .
This parameter specifies whether or not the NetWare MultiProto-
col Router for ISDN listens for incoming calls on the configured
network interface.
Default: Enabled
Options: Enabled, Disabled, Time Restricted
When Inbound Call Processing is enabled, the NetWare Multi-
Protocol Router for ISDN listens to incoming calls on the cur-
rently configured network interface.
When inbound call processing is disabled, no incoming calls for
the MSN, EAZ or DDI configured on this interface are accepted.
If Inbound Call Processing is disabled on all interfaces of an
ISDN-Controller, no incoming calls will be accepted at the ISDN
bus. The ISDN network will return the message "No user re-
Suggestion