Operation Manual

General ISDN-Controller Parameters
Netware Connect for ISDN – 4 Configuration 47
The mechanisms used to identify ISDN numbers are somewhat differ-
ent for DDI numbers, MSNs and EAZs. If you select the protocol Point-
to-Point 1TR6 or Point-to-Point DSS1, then the workstations in the LAN
must use CAPI applications that support DDI numbers.
All protocols support both terrestrial and GSM connections.
4. If your ISDN line is a PBX extension, press “Enter” and select “En-
abled”.
5. Enter the outside dialing prefix required by your PBX (if “Connected to a
PBX” is “Enabled”).
6. Enter the minimum number of digits of a number for which the outside
dialing prefix should be added automatically.
7. Confirm your entries by pressing “Enter”. The “List of ISDN-Controllers
to Load” is in the foreground once again.
8. To configure another ISDN-Controller, press the “Ins” key and repeat
steps 1–7.
9. Close the ISDN-Controller configuration dialog by pressing “Esc” and
proceed to configure the “Global Parameters”.
General ISDN-Controller Parameters
For the “International Dialing Prefix”, enter the prefix dialed before the coun-
try code when making an international call. In most European countries, this
is “00”.
For detailed information on the other parameters, please see Chapter 8,
“Configuring Global Parameters”, in the “NetWare Connect for ISDN 2.0 In-
stallation and Administration Guide”, pp. 160–161.
Configure Global Parameters
24h Maximum Physical Connection Time
per NWCI Port: Disabled
24h Maximum Charge Units: Disabled
ISDN Line Management Daily Log: sys:etc/nwciline.*
ISDN Accounting Daily Log: sys:etc/nwciacct.*
International Dialing Prefix: 00
nwci2.1.book Seite 47 Donnerstag, 13. Januar 2000 11:36 11