Operation Manual

ISDN-Controller Configuration
Netware Connect for ISDN – 4 Configuration 45
PPP Call-back
NetWare Connect for ISDN currently supports neither recall requests in ac-
cordance with RFC 1570 (LCP Extensions) nor in accordance with the Mi-
crosoft Draft (Recall Control Protocol, CBCP) on connections with Microsoft
Dial-up Networking.
This means that remote PPP users cannot issue a recall request in order to
have the server accept the connection charges. However, for security rea-
sons it is possible to call back remote PPP clients using the “Forced Dial-
back” mechanism of NetWare Connect for ISDN.
Forced Dialback is a feature of NetWare Connect for ISDN. For further infor-
mation on this feature, please see the “NetWare Connect for ISDN 2.0 Instal-
lation and Administration Guide”, pp. 141–149.
4.3 ISDN-Controller Configuration
The ISDN-Controller configuration is performed at the server console using
the NWCICON module.
To start the ISDN-Controller configuration, enter the following command at
the system console:
load nwcicon
The configuration parameters for the ISDN-Controller(s) are entered under
“Configure ISDN-Controllers” in this menu. General settings for NetWare
Connect for ISDN are entered under “Configure Global Parameters”.
In addition to the server module NWCICON, you can also use the NetWare
Administrator (NWAdmin) to check your ISDN-Controller settings from any
workstation.
NetWare Connect for ISDN Configuration Options
Configure ISDN-Controllers
Configure Global Parameters
CD-Key [ - - - ]
Exit
nwci2.1.book Seite 45 Donnerstag, 13. Januar 2000 11:36 11