Operation Manual

Installation

Netware Connect for ISDN – 3 Installation in NetWare Without NIAS and With NIAS Version 4.0 or Earlier 25

Close the ISDN-Controller configuration dialog by pressing “Esc” and

proceed to configure the “Global Parameters”.

21. For the “International Dialing Prefix”, enter the prefix dialed before the

country code when making an international call. In most European

countries, this is “00”. Close this configuration dialog by pressing

“Esc”.

For detailed information on the other parameters, please see Chapter 8

in the “NetWare Connect for ISDN 2.0 Installation and Administration

Guide”.

22. Close the ISDN-Controller configuration by selecting “Exit” and then

choose “Yes” to end the installation procedure. The following message

is displayed:

23. Press “Enter”.

24. Close the “Currently Installed Products” list by pressing “Esc”, then re-

open it by pressing “Enter”.

NetWare Connect for ISDN 2.1 now appears in the list of installed prod-

ucts as the entry “Connect v2.0.50 NetWare Connect for ISDN 2.0”.

Close the Novell NetWare server’s installation program and switch to the sys-

tem console.

Configuration of Global Parameters

24h Maximum Physical Connection Time

per NWCI Port Disabled

24h Maximum Charge

Units:

Disabled

ISDN Line Management Daily Log:

sys:etc/nwciline.*

ISDN Accounting Daily Log:

sys:etc/nwciacct.*

International Dialing Prefix:

Installation Completed Successfully.

nwci2.1.book Seite 25 Donnerstag, 13. Januar 2000 11:36 11