Operation Manual

Installation
24 Netware Connect for ISDN – 3 Installation in NetWare Without NIAS and With NIAS Version 4.0 or Earlier
13. To adjust the configuration parameters for your ISDN-Controller, select
the ISDN-Controller entry in the list and press “Enter”. The following
ISDN-Controller configuration dialog appears:
14. Press “Enter”. Select the I/O address of your ISDN-Controller.
Make sure no other driver (such as CAPI20.NLM) or application is ac-
tive for this Controller!
15. If you are using an ISA ISDN-Controller, press “Enter” and choose an
available interrupt level.
16. Press “Enter” to change the D-channel protocol.
17. If your ISDN line is a PBX extension, press “Enter” and select “En-
abled”.
18. Enter the outside dialing prefix required by your PBX.
19. Enter the minimum number of digits of a number for which the outside
dialing prefix should be added automatically. Press “Esc” to close this
configuration menu.
20. To configure another ISDN-Controller, press the “Ins” key in the “List of
ISDN-Controllers to load”, and repeat steps 14–19.
Configuration of ISDN-Controller NWCI1
I/O Base Address: 150
Interrupt Request Level: 5
ISDN D Channel Protocol: DSS1
Connected to a PBX: Disabled
Outside Line Access: 0
... Number Length: 4
nwci2.1.book Seite 24 Donnerstag, 13. Januar 2000 11:36 11