Operation Manual

Installation
Netware Connect for ISDN – 3 Installation in NetWare Without NIAS and With NIAS Version 4.0 or Earlier 23
7. At the end of the installation procedure, you are prompted to insert the
license disk. Insert the license floppy disk included in the NetWare Con-
nect for ISDN 2.1 package into the server’s floppy disk drive, and press
“Enter”.
8. Acknowledge the message “The License Information was Installed Suc-
cessfully” by pressing “Enter”.
9. Depending on the NetWare version installed, you may have to enter the
administrator name and password again in the “NDS Login” dialog. Se-
lect the option “Perform Login and Continue” and confirm these entries
by pressing “Enter”.
10. In the next dialog, use the “Enter” key to select the NDS context in
which you want to create the NetWare Connect for ISDN object. Then
begin creating the object by pressing the “Ins” key.
Do not close this dialog by pressing the “Del” key. This would abort the
creation of the NWCI object.
The NWCI object is required for configuration using the Snap-In for Net-
Ware Administrator. For further information on this Snap-In, please see
the section “NWCI Snap-In for the NetWare Administrator (NWAdmin)”
in this manual.
11. NetWare Connect for ISDN’s configuration menu appears:
The configuration parameters for the ISDN-Controller(s) are entered un-
der this menu.
12. Select “Configure ISDN-Controllers”.
One ISDN-Controller is already shown in the list with default configura-
tion parameters.
NetWare Connect for ISDN Configuration Options
Configure ISDN-Controllers
Configure Global Parameters
Exit
List of ISDN-Controllers to load
NWCI1: AVM_B1, 150, 5, DSS1
nwci2.1.book Seite 23 Donnerstag, 13. Januar 2000 11:36 11