Operation Manual

Automatic Configuration

Netware Connect for ISDN – 2 Installation in NetWare 5 or NetWare With NIAS 4.1 17

20. For the “International Dialing Prefix”, enter the prefix dialed before the

country code when making an international call. In most European

countries, this is “00”.

Close this configuration dialog by pressing “Esc”.

For detailed information on the other parameters, please see Chapter 8

in the “NetWare Connect for ISDN 2.0 Installation and Administration

Guide”.

21. Close the ISDN-Controller configuration by selecting “Exit” and then

“Yes”. The following message is displayed:

Acknowledge it by pressing “Esc”.

22. Close the “Currently Installed Products” list by pressing “Esc”, then re-

open it by pressing “Enter”.

NetWare Connect for ISDN 2.1 now appears in the list of installed prod-

ucts as the entry “NWCI v2.1.02 NetWare Connect for ISDN NIAS Edi-

tion”.

Close the NetWare server’s installation program and switch to the system

console.

2.3 Automatic Configuration

1. At the system console, start the automatic configuration by entering:

load nwccon

2. First, set the “Connect Rights Level”. To do so, enter the name and

password of the Administrator (Admin) or a user with equivalent rights.

Confirm by pressing “Enter”.

“Connect Rights Level” refers to a container in the NDS. All users in this

container and its subcontainers can access NetWare Connect for ISDN

without additional configuration or granting user rights. By default this

is the server’s root. This means that all users entered in the NDS have

access to NetWare Connect for ISDN.

For detailed information on granting user rights, see the document TID

1005092, available from Novell’s Web site at

http://www.novell.com.

The NetWare Communication Service Installation

has been completed.

nwci2.1.book Seite 17 Donnerstag, 13. Januar 2000 11:36 11