Operation Manual

Installation
14 Netware Connect for ISDN – 2 Installation in NetWare 5 or NetWare With NIAS 4.1
2.2 Installation
To install NetWare Connect for ISDN NIAS Edition 2.1, proceed as follows:
1. If you are working with NetWare 5, enter the following command at the
system console:
nwconfig
For other NetWare versions with NIAS 4.1, enter the following command
at the system console:
load install
This loads the Novell NetWare server’s software installation program.
The menu “Configuration Options” or “Installation Options” appears.
2. In this menu, select the item “Product Options”. The menu “Other In-
stallation Actions” appears.
3. Select the item “View/Configure/Remove installed products”. Press
“Enter”. A list of all the products installed appears.
Make sure that the product “NIAS 4.1 Novell Internet Access Server” is
present in this list.
If the program NIAS 4.1 is not installed on your NetWare server, install
it now before you install NetWare Connect for ISDN 2.1.
4. To continue with the installation, press the “Ins” key.
An input box appears prompting you to enter the path to the
installation files. The default path shown is the floppy disk drive A:\.
Press “F3” and enter the path to the NetWare Connect for ISDN installa-
tion files. The exact path to specify depends on how your CD-ROM drive
is addressed.
If you have mounted the CD-ROM in NetWare, then enter the path as fol-
lows:
nwci:\nwci2\disk1
If you access your CD-ROM drive as a DOS device, enter the path using
a DOS-style drive letter:
<CD-ROM drive>:\nwci2\disk1
In this case, NetWare warns you that accessing the CD-ROM through a
DOS driver might cause a driver conflict. Select “Continue CD-ROM ac-
cess”.
nwci2.1.book Seite 14 Donnerstag, 13. Januar 2000 11:36 11