Operation Manual

123
5 Troubleshooting – MS-DOS
to load the AVM Mobile ISDN-Controller M2 without
Card and Socket Services. In this case, the Controller is
configured to the I/O address 150. Make sure this
resource is not allocated to another hardware component.
Card Services release 2.10 or later required.
The Card Services version installed in your computer is
outdated. Contact your dealer to obtain Card Services in
Version 2.10 or later.
No Card Service client installed (PCENABLE, CSALLOC, PCMSCD
...).
There is no Card Service client installed in your computer.
Contact your dealer.
No AVM ISDN-Controller found.
Either you have forgotten to insert the AVM Mobile
ISDN-Controller M2 in the PCMCIA slot, or it is not
inserted correctly. Insert the card firmly and try again.
No interrupt available for slot x.
All possible interrupts are already in use by other hardware
components. Remove another PCMCIA adapter and try
again.
No port available for slot x.
All possible I/O addresses are already in use by other
hardware components. Remove another PCMCIA adapter
and try again.
Faulty Connections
Errors that occur during the connection may be reported
by your application program. The driver software can
only verify that the AVM Mobile ISDN-Controller M2 is
operating correctly, and does not generate error
messages for disturbances of other kinds.
In order to function correctly, the Controller must be
properly connected to an ISDN line or a GSM mobile
phone. Errors that occur during dialing or during a
connection are often due to a loose or disconnected
cable. Connect the correct cable securely.