Operation Manual

CAPI 2.0 and Euro-ISDN Messages
NT/MPRI – 7 Messages 92
0x3006 B3 protocol parameter not supported[#3006]
This message indicates that the driver does not provide the
protocol options required by the application.
0x3007 B protocol combination not supported[#3007]
This message indicates internal application errors. Protocol
conflicts have occurred, The B protocols used are not compati-
ble and may not be used together.
0x3008 NCPI not supported[#3008]
The B-channel protocols in use are not compatible.
0x3009 CIP value unknown[#3009]
The service requested by the application is not implemented in
the controller software.
0x300A Flags (signals) not supported (reserved bits)[#300A]
This message indicates internal application errors. The signals
(flags) requested by the application are not supported by CAPI.
0x300B Facility not supported[#300B]
The ISDN driver does not support the requested supplementa-
ry service. Please contact your software manufacturer for more
information.
0x300C Data length not supported by current protocol[#300C]
This message indicates internal application errors.
0x300D Reset procedure not supported by current protocol[#300D]
This message indicates internal application errors. Contact
your software manufacturer for more information about appli-
cations that conform to CAPI.
0x3301 Protocol error, layer 1 (broken line or B channel removed by
signaling protocol)[#3301]
No connection could be established between the terminal
equipment and /or the exchange. The call set-up failed at layer
1 of the ISDN protocol. No messages could be exchanged be-
tween the terminal equipment and the network terminator or
local switch. Possible causes include: cable not correctly con-
nected; cable connectors miswired or wrong sockets used; net-
work termination not correctly enabled or not connected cor-
rectly to the line; defective terminal equipment at the bus
blocking communication.
Number Messages/Explanations
ntmpri-e.book Seite 92 Donnerstag, 28. Februar 2002 11:26 11