Operation Manual

CAPI 2.0 and Euro-ISDN Messages
NT/MPRI – 7 Messages 90
0x1102 Illegal command or subcommand, or message length less
than 12 bytes[#1102]
This message indicates either internal application errors or ap-
plications that do not conform to CAPI.
0x1103 The message could not be accepted due to a full queue condi-
tion! The error does not affect messages for other PLCI or NCCI
controllers[#1103]
This message indicates either internal application errors or ap-
plications that do not conform to CAPI.
0x1105 Queue overflow; a message was lost! Configuration error, the
only recovery method is to perform a CAPI_RELEASE[#1105].
This message indicates internal application errors. Insufficient
application capacities require reconfiguration.
0x1106 Unknown notification parameter[#1106]
This message indicates internal application errors.
0x1107 The message could not be accepted due to an internal busy
condition[#1107]
This message indicates either internal application errors or ap-
plications that are not conform to CAPI.
0x1108 OS resource error (no memory?)[#1108]
This message indicates that the operating system is over-
loaded. Close all applications and restart the operating sys-
tem.
0x1109 Common-ISDN-API Version 2.0 is not installed[#1109]
This message indicates that CAPI 2.0 is no longer available. It
was unloaded while an application was active. Reload CAPI
2.0.
0x110A Controller does not support external equipment[#110A]
The ISDN driver does not support the equipment required by
the application. This message indicates internal application er-
rors.
0x110B Controller supports only external equipment[#110B]
The ISDN driver does not support the equipment required by
the application. This message indicates internal application er-
rors.
0x2001 Message not supported in current state[#2001]
This message indicates internal application errors.
Number Messages/Explanations
ntmpri-e.book Seite 90 Donnerstag, 28. Februar 2002 11:26 11