Operation Manual

CAPI 2.0 and Euro-ISDN Messages
89 NT/MPRI – 7 Messages
0x1002 Logical block size too small, must be at least 128
bytes[#1002]
This message indicates internal application errors.
0x1003 Buffer exceeds limit of 64 kBytes[#1003]
This message indicates internal application errors.
0x1004 Message buffer too small, at least 1024 bytes required[#1004]
This message indicates internal application errors.
0x1005 Max. number of logical connections not supported[#1005]
This message indicates that the controller has not been config-
ured adequately. Check the configuration of your controller.
Change the settings so that it supports more logical connec-
tions supported.
0x1007 The message could not be accepted due to an internal busy
condition[#1007]
This message indicates either internal application errors or ap-
plications that are not conform to CAPI.
0x1008 OS resource error (no memory?)[#1008]
This message indicates that the operating system is over-
loaded. Close all active applications and restart the operating
system.
0x1009 Common-ISDN-API Version 2.0 not installed[#1009]
This message indicates that CAPI 2.0 is not installed. Load
CAPI 2.0.
0x100A Controller does not support external equipment[#100A]
The ISDN driver does not support the equipment required by
the application. This message indicates an internal application
error.
0x100B Controller only supports external equipment[#100B]
The ISDN driver does not support the equipment required by
the application. This message indicates an internal application
error.
0x1101 Illegal application number[#1101]
This message indicates internal application errors. The appli-
cation has crashed. Contact your software manufacturer and
ask about applications that conform to CAPI.
Number Messages/Explanations
ntmpri-e.book Seite 89 Donnerstag, 28. Februar 2002 11:26 11