Operation Manual

Configuring a Dynamic Leased Line
69 NT/MPRI – 4 Special NT/MPRI Settings
Configuring a Dynamic Leased Line
The following settings are required for the example configurations de-
scribed in this section:
– Create a “Dial-up Connection” with an additional static B
channel and two additional dynamic B channels
– Configure the leased line D64S2 for one controller and reserve
both B channels for the newly created call destination.
– Configure the line type “Primary Rate Access” for a second net-
work adapter.
Configuring the Dial-up Connection
1. Select the input mask “No Profile” from the “Configuration / Call
Destinations / New Call Destination”.
2. Make the settings specified in the table. Parameters which are not
listed in the table keep their default values. If no default setting is
entred, no entry is necessary.
3. Save the destination.
Parameter Action
“Name” Enter an unambiguous name for
the leased line
“Authentication at Remote Site”:
“Name”
Enter the name of the local
NT/MPRI station (server name)
“Authentication at Local Site”:
“Name”
Enter the name of the router station
at the remote site
“IP” on
“Static Route”:
“Network address”, “Mask”
the values for the network to be ac-
cessed at the remote site (e.g.
“192.168.10.0” and “24”)
“NetBIOS Filter” Enable “Not active”
“Channel bundling”:
“Additional static B channels”
Select the value 1 B channel
“Channel bundling”: “Additional B
channels on Demand”
Select the value 2 B channels
“Max. Number of B channels” Select the value 4 B channels
ntmpri-e.book Seite 69 Donnerstag, 28. Februar 2002 11:26 11