Operation Manual

Configuring a Static Leased Line
NT/MPRI – 4 Special NT/MPRI Settings 66
2. Activate “Leased line” at the upper right of the input mask to ac-
cess the mask specific for leased lines. Make the settings listed in
the table. Parameters which are not listed in the table keep their
default values. If no default setting is entred, no entry is necessa-
ry.
3. Save the destination.
Testing and Configuring the Static Leased Line at the Remote Site
1. Restart the NT/MPRI service (“Special / Restart Services”).
2. Start tracing packets by selecting “ISDN/ADSL-Controller / Net-
work Adapter” in the “Monitor / Trace Packets” menu and clicking
the “REC” button.
3. As the LQRP packets (Line Quality Report Protocol) are sent con-
stantly, these must be visible in the session recording.
Parameter Action
“Name” Enter an unambiguous name for
the leased line
“Authentication at Remote Site”:
“Name”
Enter the name of the local
NT/MPRI station (server name)
“Authentication at Local Site”:
“Name”
Enter the name of the router station
at the remote site
“For Leased Line use” Enter the ISDN-Controller to be
used and configured for the leased
line
“IP” Enable
“Static Route”:
“Network address”, “Mask”
Enter the values for the network to
be accessed at the remote site (e.g.
“192.168.10.0” and “24”)
“NetBIOS Spoofing” Enable “Negotiate”
“NetBIOS Filter” Enable “Not active”
ntmpri-e.book Seite 66 Donnerstag, 28. Februar 2002 11:26 11