Operation Manual

Configuring a Static Leased Line
65 NT/MPRI – 4 Special NT/MPRI Settings
Configuring a Static Leased Line
The following settings are required for the example configurations de-
scribed in this section:
– Create a “New Leased Line” as a call destination
– Configure the leased line D64S (1*64 K) for Controller 1 and re-
serve the first B channel for the newly created call destination.
Controller Settings
1. Make sure that the DSS1 driver for the ISDN-Controller to be used
by the leased line is installed.
2. Use the “Configuration / Server Settings / ISDN- and ADSL-Con-
troller” menu command in the NT/MPRI Manager to select the
ISDN-Controller intended for the leased line.
If the line is an ISDN BRI, activate the “Leased line” option and se-
lect the desired line type from the adjacent list.
If the line is an ISDN PRI (primary rate access), activate the “Pri-
mary rate interface” option and save the settings.
ISDN-Controller 1 configured for a leased line
Configuring a Call Destination for the Leased Line
1. Select the input mask “Without Profile” from the “Configuration /
Call Destinations / New Call Destination”.
ntmpri-e.book Seite 65 Donnerstag, 28. Februar 2002 11:26 11