Operation Manual

Internet Access via ADSL
45 NT/MPRI – 3 Configuration and Operation of the NT/MPRI: The Basics
Step 1:
Open the pre-configured call destination “UUNet over ADSL”. A mask
opens in which the pre-configured data can be changed. Check the in-
formation and add the following if necessary:
The pre-set budget is set to a low monthly value. This value should
probably be changed for normal operation. The status of this setting is
set to “Only configured, not active”. Set this setting to “Active”.
To ensure that the ADSL access is used when a connection to this call
destination is established, the ADSL-Controller must be linked to this
call destination. The ADSL-Controller is linked by reserving the PPPoE
channel of the ADSL-Controller for the call destination “UUNet over
ADSL” under “Configuration / Server Settings / ISDN- and ADSL-Con-
trollers”.
If you have made any changes to the configuration, save them now.
Then select the menu command “Special / Restart Service” and click
the button “Restart Service”.
Step 2:
Next select the menu command “Connection Management”. In the
destination “UUNet over ADSL”, click the “IP” button in the “Action”
column.
A connection to the Internet provider is established. Use the web
browser to visit any Internet sites of interest. Click the “IP” button
again to clear the connection.
Parameter Action
Name:
Enter “UUNet over ADSL”
Number: Enter the [Telephone number the PoP of
UUNet]
Authentication at Remote
Site:
Enter the [line ID][telephone no.][co-user
suffix]
Password: Enter [UUNet Password of the co-user]
Inactivity Timeout: Enable “Always after 60 seconds”
Status of this configura-
tion:
Active
ntmpri-e.book Seite 45 Donnerstag, 28. Februar 2002 11:26 11