Operation Manual

NT/MPRI Messages
105 NT/MPRI – 7 Messages
Incoming call to <number dialed> rejected. This CLI <CLI> is not allowed
to dial in.
The security settings specify that all incoming calls should be sub-
jected to a CLI number check. The CLI number received was not found
in the local CLI number database; therefore the call was rejected.
Incoming logical connection to <call destination> (<CLI>) lost (local).
The local site lost the incoming logical connection to the remote site.
Logical connection cleared after inactivity.
The logical ISDN connection was cleared down due to inactivity.
Logical connection to <call destination> lost (local).
The local site lost the outgoing logical connection to the remote site.
Outgoing call to <call destination> (<number>) not possible. Call desti-
nation budget or global thresholds reached.
If the destination-specific budget was reached, the call destination is
blocked for all outgoing connections, including call waiting signals
over the D channel.
If a global threshold was reached, all outgoing connections are locked,
including signaling over the D channel.
To release the lock, enter a higher budget or threshold value.
Outgoing call to <call destination> accepted by remote site, although
cost allocation is set to “Remote Site”.
The outgoing call was accepted by the remote site and charges are be-
ing incurred at the local site. The remote site should have refused the
call and called back in order to bear the connection charges. Make sure
that the CLI transmitted by the local router is registered correctly at the
remote site.
Packet <description> accepted due to rule <no.> from <profile name>.
An IP firewall message indicating that the packet described was ac-
cepted. The filter profile is indicated along with the position of the ap-
plicable rule within the filter.
ntmpri-e.book Seite 105 Donnerstag, 28. Februar 2002 11:26 11