Operation Manual

NT/MPRI Messages
NT/MPRI – 7 Messages 104
Incoming call from <call destination> (<CLI>) rejected. Several calls for
this destination are already being processed.
This message reports that the maximum number of calls which can be
processed simultaneously for one call destination has been reached.
The incoming call is rejected.
Incoming call from <call destination> (<CLI>) rejected. The maximum
number of bundled channels to this call destination is already set up.
This message indicates that no more channels are available for chan-
nel bundling. The configured maximum number of B channels is al-
ready being used for this connection.
Incoming call from <call destination> (<CLI>) rejected. The maximum
number of supported connections has been reached.
This message indicates that no more connections are supported at this
time. The incoming call is rejected.
Incoming call from <CLI> for <number dialed> cannot be accepted. All B
channels in use.
The incoming call could not be accepted because all B channels on the
ISDN-Controller called are already being used for other physical con-
nections.
Incoming call from <CLI> for <number dialed> rejected. All B channels
in use.
The incoming call could not be accepted because all B channels on the
ISDN-Controller called are already being used for other physical con-
nections.
Incoming call from <CLI> for <number dialed> rejected. The
MSN/EAZ/DDI dialed is not configured.
The MSN/EAZ or DDI dialed was not configured for use by the NT/MPRI.
The call may have been intended for another application. As a result,
the incoming call was not accepted.
Incoming call from <CLI> rejected. The local router’s own endpoint dis-
criminator was received.
The local router attempted to set up a connection to itself.
ntmpri-e.book Seite 104 Donnerstag, 28. Februar 2002 11:26 11