Operation Manual

NT/MPRI Messages
NT/MPRI – 7 Messages 100
7.2 NT/MPRI Messages
The following symbols are used in the message descriptions below:
The messages are listed in alphabetical order.
Accepting incoming call from <call destination> (<number>). Setting up
B channel.
This message indicates that an incoming call was accepted successful-
ly and that the B-channel connection is being established.
Authentication at remote site <call destination> failed.
The local router was not recognized by the remote router. Authentica-
tion failed.
Authentication of remote site <call destination> at the local site failed.
The remote router was not recognized by the local router. Authentica-
tion failed.
B-channel connection to <call destination> (<number>) is cleared.
The physical connection to the specified call destination has been
cleared down.
B-channel connection to <call destination> (<number>) is set up.
The physical connection to the specified call destination was success-
fully established.
<number> ISDN number or CLI
<CLI> CLI number
<number called> ISDN number called, for incoming calls
<call destination> name of the call destination
<protocol> network protocol used (IP or IPX)
<description> brief packet description
<no.> position of the rule applied within a filter profile
<profile name> name of the filter profile
ntmpri-e.book Seite 100 Donnerstag, 28. Februar 2002 11:26 11