Operation Manual

23
3 Driver Software Installation – MS-DOS
/L#xxxx sets the interface card’s I/O address
/I#xx sets the interface card’s interrupt level (xx is a
hexadecimal number from 08 to 0F; see table)
Note: The value of the command line parameter “/I#” is
not itself the interrupt (IRQ) level! To determine the value
for this parameter that corresponds to the desired inter-
rupt level, refer to the following table:
Table Choosing a valid interrupt
The program AFSERVER.EXE runs a test routine on the
AVM ISDN-Controller T1/T1-B. Please note that the
first argument, “-:l”, is formed with a lower-case L, not with
the numeral 1!
Example:
@cta2.exe /N#01 /L#220 /I#0D /SP#05
@afserver -:l #220 -:b worm.b4
The first command sets the PC interface card with the
board number “01” to the I/O address “220” and the
interrupt 11. The second command tests the ISDN-Con-
troller that is set to the I/O address 220.
The argument “/SP#xx” sets the serial link speed. The
preset value, “05”, must not be changed.
xx#I/nixxfoeulaVxx#I/nixxfoeulaV
xx#I/nixxfoeulaV
xx#I/nixxfoeulaVxx#I/nixxfoeulaV
tpurretnisteStpurretnisteS
tpurretnisteS
tpurretnisteStpurretnisteS
level
3tiB3tiB
3tiB
3tiB3tiB2tiB2tiB
2tiB
2tiB2tiB1tiB1tiB
1tiB
1tiB1tiB0tiB0tiB
0tiB
0tiB0tiBxeHxeH
xeH
xeHxeH
1000 803QRI
100 1 905QRI
10 10 A07QRI
10 11 B09QRI
1100 C001QRI
1101 D011QRI
1110 E021QRI
1111 F051QRI
.0ottesdnadesutonera7ot4stiB