Operation Manual

Error Messages in Novell NetWare
40 Controller C4 – 8 Troubleshooting
Error Messages in Novell NetWare
Error Message on loading the ISDN-Controller: “Installation
Error. Interrupt <xx> not available.”
Possible cause: There are no IRQs (interrupts) available to
the PCI bus.
Remedy: Run your BIOS setup (see the PC or mainboard ma-
nual) and allocate at least one free IRQ for use by PCI adap-
ters.
Example (Award BIOS): In the BIOS main menu, select
“PnP/PCI Configuration”, then set “IRQ x assigned to:
PCI/ISA PnP”.
If you combine adapters without Plug-and-Play support and
PCI or ISA Plug-and-Play cards in one system, then the re-
sources (I/O addresses and IRQ levels) used by the hardware
without Plug-and-Play support should be so designated in
the computer’s BIOS. Otherwise, system resources may be
allocated to more than one adapter, resulting in mal-
functions. Please see your PC or mainboard manual.
Error Message: “CAPI not loaded.”
Possible cause: You tried to start an ISDN application with-
out loading the AVM-ISDN Controller C4 first.
Remedy: Load the ISDN-Controller by entering load
capi20
at the system console, then start your ISDN ap-
plication.
Error Message: “Error in configuration file, no ISDN-
Controller defined.”
Possible cause: During the AVM-ISDN Controller C4 installa-
tion process, the configuration file CAPI20.CFG is created.
This error occurs if you later edit this file manually and cor-
rupt the ISDN-Controller definition(s) it contains.
Remedy: Repeat the complete AVM ISDN-Controller C4 instal-
lation procedure.