Operation Manual

Removing the Driver Software
Controller C4 – 5 Driver Software Installation in Novell NetWare 25
Each subsequent ISDN-Controller C4 must be configured
with the same driver version as the first ISDN-Controller C4
installed (Stand-Alone CAPI or CAPI for Novell CAPI Mana-
ger).
Configure the new ISDN-Controller as described in the sec-
tion “Configuration for Stand-Alone CAPI” on page 22, or
“Configuring and Loading the Driver Version for Novell CAPI
Manager” on page 23.
Active AVM ISDN-Controllers for the ISA and PCI buses may
also be combined in one computer. In this case, install the
ISA card as described in its manual, using the installation
program on the original disk or CD-ROM that came with it.
5.5 Removing the Driver Software
Removing a Single ISDN-Controller
To remove the ISDN-Controller C4 driver from Novell NetWare
4.11 or higher, proceed as follows:
1. First remove the ISDN-Controller card from its slot in the
PC.
2. Restart the server and enter the following command at
the system console:
load c4setup
3. The “List of ISDN-Controllers to load” appears. The
ISDN-Controller you have just removed is already mis-
sing from this list.
4. Press the “Esc” key.
5. When prompted to confirm that you want to save the
changes, answer “Yes”.
6. Close the menu by selecting “Exit”.
This completes the uninstallation procedure for the ISDN-
Controller C4 driver software.