Operation Manual

Installing Additional ISDN-Controllers
24 Controller C4 – 5 Driver Software Installation in Novell NetWare
5. In the “Board Name” input box, enter a name for the
new ISDN-Controller C4.
6. In the “WHSMCAPI Board Configuration” dialog you
may now configure the ISDN-Controller C4. Select the
entry “Select to View” and press “Enter”.
7. Answer “Yes” to the question about automatic loading.
8. In the next dialog, select the ISDN-Controller “AVMC4”
and press “Enter”.
9. Enter the correct settings for the following parameters:
– Switch Type (D-channel protocol used on your ISDN
line.)
– Line Config (MTP = point-to-multipoint; PPT = point-
to-point) for each S
0
interface.
10. Close the configuration dialog and then the list of ISDN-
Controllers by pressing “Esc”. Answer “Yes” when
prompted to confirm that you want to save the new set-
tings.
11. To complete the configuration procedure, the system
must be updated and the ISDN-Controller loaded. Se-
lect the command “Reinitialize System” in the “Inter-
networking Configuration” menu and confirm by selec-
ting “Yes”.
12. Close the configuration program by selecting “Exit”.
Answer “Yes” when prompted to confirm that you want
to save the new settings.
The ISDN-Controller C4 for CAPI Manager is now configured
and loaded.
5.4 Installing Additional ISDN-Controllers
To install another ISDN-Controller C4, first insert the ISDN-
Controller card in the computer, then configure the driver
software. Note the number of the PCI slot in which you install
the ISDN-Controller C4: this number is required in the driver
configuration.