Operation Manual

Configuring and Loading the Driver Version for Novell CAPI Manager
Controller C4 – 5 Driver Software Installation in Novell NetWare 23
4. Move the cursor to the entry you want to change and
press “Enter”.
5. Select the new value for the given parameter and con-
firm by pressing “Enter”.
6. Repeat steps 4 and 5 until all the settings are correct.
7. Close the configuration program by pressing the “Esc”
key twice.
8. When prompted to confirm that you want to save the
new settings, select “Yes”.
Loading and Unloading the Driver Software
To load the driver software, enter the following command at
the system console:
load capi20
Press “Enter”. A message appears to notify you that the
ISDN-Controller has been loaded and the CAPI interface is
available.
To unload the driver software, type
load capi20 -d
and press “Enter”.
Configuring and Loading the Driver Version for
Novell CAPI Manager
To configure the AVM ISDN-Controller C4, proceed as follows:
1. Enter the following command at the system console:
load inetcfg
2. The “Internetworking Configuration” menu appears.
Select the item “Boards” in this menu and press
“Enter”.
3. A list of the ISDN-Controllers already configured ap-
pears. Press the “Ins” key.
4. In the menu labeled “Select A Driver”, select the entry
“WHSMCAPI” and press “Enter”.