Operation Manual

Configuring the ISDN-Controller C4

22 Controller C4 – 5 Driver Software Installation in Novell NetWare

Press “Esc” to close the display and confirm by selec-

ting “Yes”.

9. Press “Esc” until the “Configuration Options” menu is

in the foreground again.

10. Select “Exit” to close the configuration program.

Once the ISDN-Controller C4 has been installed, it must be

configured before it is ready to operate. Follow the configu-

ration instructions in the following section.

5.3 Configuring the ISDN-Controller C4

The procedure for configuring the ISDN-Controller C4 invol-

ves setting the D-channel protocol and the line configuration

for each of the S

interfaces.

Configuration for Stand-Alone CAPI

1. Enter the following command at the system console:

load c4setup

2. The “List of ISDN-Controllers to load” appears. This list

shows the available ISDN-Controllers with their I/O

address, interrupt, D-channel protocol and PCI slot set-

tings. Use the arrow keys to select the ISDN-Controller

C4 that was just installed and press “Enter”.

3. The configuration dialog that appears shows the cur-

rent settings of the ISDN-Controller C4 and its S

lines.

Configuration of ISDN-Controller-2: AVM C4 PCI

I/O Base d400

Interrupt Level 7

D Channel Protocol DSS1

Port 1 Point to Point: yes

Port 2 Point to Point: yes

Port 3 Point to Point: yes

Port 4 Point to Point: yes

Data Compression no