Operation Manual

Configuring the ISDN-Controller C4
18 Controller C4 – 4 Driver Software Installation in Windows NT
In the “Start / Programs” menu, you will find a new program
group named “AVM”. This group contains the icons “C4
Load”, “C4 Unload”, “C4 Setup”, “C4 Test”, “C4 Readme”
and “AVM Internet Home Page.” The last is a link to AVM’s
WWW server.
By default, the ISDN-Controller is loaded automatically each
time Windows NT 4.0 is started. This takes place before pro-
grams in the “Start” group run, so that you may include
CAPI-based communications programs in your “Start” group
if desired.
4.2 Configuring the ISDN-Controller C4
To change the settings for the D-channel protocol and line
type on the S
0
interfaces, and to activate or deactivate data
compression, start the program “C4 Setup” in the “AVM”
program group. Select the ISDN-Controller C4 in the list of in-
stalled controllers and follow the instructions displayed.
4.3 Installing Additional ISDN-Controllers
If you would like to add another AVM ISDN-Controller C4, re-
peat the entire installation procedure above. Begin by in-
stalling the hardware as described in Chapter 2. Then run the
program “C4 Setup” in the “AVM” group and select “New”
(Add a Controller). Follow the instructions displayed by the
program.
Active AVM ISDN-Controllers for the ISA and PCI buses may
also be combined in one computer. In this case, install the
additional controller as described in its manual, using the in-
stallation program on the original disk or CD supplied with it.
4.4 Removing the Driver Software
To remove the AVM ISDN-Controller C4 driver software from
the Windows NT 4.0 system, proceed as follows:
1. Open the Windows NT Control Panel (“Start” menu,
“Settings”).