Operation Manual

Configuring the ISDN-Controller C4
Controller C4 – 3 Driver Software Installation in Windows 2000 13
6. A message appears reporting that the “Digital Signa-
ture” for the Controller C4 was not found. Confirm with
“Yes” to continue with installation.
7. The next dialog reports that no digital signature was
found for the AVM NDIS WAN CAPI driver, either. Con-
firm by clicking “Yes” again to continue the installation.
8. Now enter the D-channel protocol to be used and con-
firm by clicking “Next”.
9. In the “ISDN Multiple Subscriber Number (MSN)” win-
dow, enter the MSNs.
Then click “Next”.
10. Close the installation by clicking “Finish”.
This concludes the Controller C4 installation. The ISDN-Con-
troller is ready for operation.
After installation, CAPI 2.0 and the AVM NDIS WAN CAPI
Driver are available for use. For detailed information about
the AVM NDIS WAN CAPI Driver and the two other AVM sy-
stem drivers, see the section “The AVM System Drivers” on
page 30
3.2 Configuring the ISDN-Controller C4
The default settings for all four S
0
interfaces are as follows:
After installation you have the opportunity to change the line
types of the S
0
interfaces, the D-channel protocol of the
ISDN-Controller, and the multiple subscriber numbers
(MSNs).
Proceed as follows to configure the Controller C4:
1. Open the Device Manager by clicking “Start / Settings /
Control Panel / System” and selecting the “Hardware”
page.
2. Click the “+” preceding the “Network adapters” entry.
Line type Point-to-multipoint
D-channel protocol DSS1