Operation Manual

Error Messages in Novell NetWare
ISDN-Controller C2 – 10 Troubleshooting 55
Error Messages in Novell NetWare
Error message on loading the controller: “Installation Error.
Interrupt <xx> not available.”
Possible cause: There are no IRQs available to the PCI bus.
Remedy: Run your BIOS setup and release at least one free
IRQ for use by PCI adapters. Please see your PC or mainboard
manual.
Example (Award BIOS): in the BIOS main menu, select
“PM/PCI Configuration”, then set “IRQ x assigned to: PCI/ISA
PnP”.
If you combine adapters without Plug-and-Play support (Leg-
acy) and PCI or ISA Plug-and-Play cards in one system, then
the resources (I/O addresses and IRQ levels) used by the
hardware without Plug-and-Play support should be so desig-
nated in the computer’s BIOS. Otherwise, system resources
may be allocated to more than one adapter, resulting in mal-
functions. Please see your PC or mainboard manual.
Error message: “CAPI not loaded.”
Possible cause: You tried to start an ISDN application with-
out loading the AVM ISDN-Controller C2 first.
Remedy: Load the ISDN-Controller C2 by entering capi20 at
the system console and then start your ISDN application.
Error message: “Error in configuration file, no ISDN-
Controller defined.”
Possible cause: During the ISDN-Controller C2's installation,
the configuration file CAPI20.CFG is created. If you later edit
this file manually and corrupt the ISDN-Controller’s defini-
tion(s) it contains, the error occurs.
Remedy: Repeat the complete installation of the AVM ISDN-
Controller C2.
c2-e.book Seite 55 Mittwoch, 27. November 2002 3:24 15