Operation Manual

Installing Additional ISDN-Controllers
40 ISDN-Controller C2 – 7 Installation in Linux
7.3 Installing Additional ISDN-Controllers
Up to four active AVM ISDN-Controllers can be installed in
your computer. Active AVM ISDN-Controllers for the ISA, PCI
and PCMCIA buses can also be combined in the same sys-
tem. It is not possible to use active and passive AVM ISDN-
Controllers (like FRITZ!Card) at the same time.
To install an additional active AVM ISDN-Controller, simply
perform the installation routine for the desired controller
again. An individual configuration (D-channel protocol and
line type) can be assigned to each ISDN-Controller.
If a mixed installation of an ISDN-Controller C2 together with
an AVM ISDN-Controller C4 is intended, please install the
Controller C4 first to ensure the correct S
0
interface assign-
ment.
Only CAPI applications which can be configured for multiple
ISDN-Controllers can be used. The CAPI4HylaFAX module
and the CAPI plug-in allow the configuration of multiple con-
trollers.
7.4 Removing the ISDN-Controller C2
To remove the AVM ISDN-Controller C2, proceed as follows:
1. Exit all CAPI applications.
2. Open a console and enter the following command:
capiinit stop
3. Delete the AVM ISDN-Controller C2 entry in the
“/etc/capi.conf” file.
4. Shut down the computer and remove the ISDN-
Controller C2.
5. Restart your computer.
This completes the removal of your AVM ISDN-Controller C2.
c2-e.book Seite 40 Mittwoch, 27. November 2002 3:24 15