Operation Manual

Removing All ISDN-Controllers and Their Driver Software
32 ISDN-Controller C2 – 6 Installing the Driver Software in Novell NetWare
Removing All ISDN-Controllers and Their Driver
Software
If you want to remove the only ISDN-Controller C2 installed
in your computer, also proceed as described below.
To remove all of the installed C2 ISDN-Controllers and their
drivers at once, proceed as follows:
The uninstallation sequence for the driver version with
Stand-Alone CAPI is slightly different from that for the
version for the Novell CAPI Manager. The steps which
differ between versions are marked accordingly.
1. Stand-Alone CAPI only: When the driver software is
loaded automatically by the AUTOEXEC.NCF file, delete
the entry “load capi20” from the AUTOEXEC.NCF file in
the SYS:\SYSTEM folder.
2. Switch off the computer and disconnect it from its pow-
er supply, then remove all ISDN-Controller cards.
3. Plug in the power cable again and restart the computer.
4. Switch to the installation folder. Enter the following
commands at the command line:
cd nwserver
5. Load the server with the following command:
server
6. Stand-Alone CAPI only: Enter the following command at
the system console:
load inetcfg
The “Internetworking Configuration” window appears.
7. Stand-Alone CAPI only: Select the item “Boards” in this
menu and press “Enter”.
The “Configured Boards” list appears. This list contains
all of the network adapters that have already been con-
figured, including the ISDN-Controller.
8. Stand-Alone CAPI only: Select an ISDN-Controller C2
and press “Del”.
c2-e.book Seite 32 Mittwoch, 27. November 2002 3:24 15