Operation Manual

Removing One of Multiple ISDN-Controllers
30 ISDN-Controller C2 – 6 Installing the Driver Software in Novell NetWare
In both versions, start uninstallation by following the instruc-
tions below:
1. Switch off the computer and disconnect it from its pow-
er supply, then remove the ISDN-Controller card.
2. Plug in the power cable again and restart the computer.
3. Switch to the installation folder and enter the following
command at the system console:
cd nwserver
4. Load the server with the following command:
server
5. Continue with the instructions in the section “Removing
the ISDN-Controller C2 with Stand-Alone CAPI” on
page 30 or “Removing the ISDN-Controller C2 with Novell
CAPI Manager” on page 31.
Removing the ISDN-Controller C2 with Stand-Alone CAPI
1. Enter the following command at the system console:
load c2setup
The “List of ISDN-Controllers to load” appears. The
ISDN-Controller you have just removed is already miss-
ing from this list.
2. Press the “Esc” key.
3. When prompted to confirm that you want to save the
changes, select “Yes”.
4. Exit the menu by selecting “Exit”.
The ISDN-Controller C2 is no longer available to the system.
c2-e.book Seite 30 Mittwoch, 27. November 2002 3:24 15