Operation Manual

Installing Additional ISDN-Controllers
ISDN-Controller C2 – 6 Installing the Driver Software in Novell NetWare 29
6.4 Installing Additional ISDN-Controllers
To install another ISDN-Controller C2, first insert the ISDN-
Controller C2 into the computer, then configure the driver
software. Note the number of the PCI slot in which you install
the ISDN-Controller C2: this number is required in the driver
configuration.
Each subsequent ISDN-Controller C2 must be configured
with the same driver version as the first ISDN-Controller C2
installed (Stand-Alone CAPI or CAPI for Novell CAPI Manag-
er).
Configure the new ISDN-Controller C2 as described in the
section “Configuration of Novell NetWare with Stand-Alone
CAPI” on page 25 or “Configuring and Starting ISDN-
Controller C2 Operation with the Novell CAPI Manager” on
page 27.
Active AVM ISDN-Controllers for the ISA and PCI buses may
also be combined in one computer. If you want to add anoth-
er active ISDN-Controller, carry out the controller installation
procedure as described in the appropriate manual, using the
installation program on the original disk or CD-ROM supplied
with it.
6.5 Removing the ISDN-Controller C2
There are a number of procedures for removing the ISDN-
Controller C2. The amount of ISDN-Controller C2 installed
and the amount of ISDN-Controller C2 to be removed deter-
mine which procedure should be used in each case. It also
makes a difference whether the ISDN-Controller C2 is used
with Stand-Alone CAPI or with the Novell CAPI Manager.
Removing One of Multiple ISDN-Controllers
Select this uninstallation program when multiple ISDN-
Controller C2s are installed in your computer and you want to
remove only one of them. The method of uninstallation from
the Stand-Alone CAPI version is different from that for the
Novell CAPI Manager.
c2-e.book Seite 29 Mittwoch, 27. November 2002 3:24 15