Operation Manual

Configuring and Starting ISDN-Controller C2 Operation with the Novell CAPI Manager
28 ISDN-Controller C2 – 6 Installing the Driver Software in Novell NetWare
6. Configure the ISDN-Controller C2 in the “WHSMCAPI
Board Configuration” window. Move the highlight to
“Select to View” and press “Return”.
7. When prompted to choose whether the ISDN-Controller
should be loaded automatically, select “Yes”.
8. In the next dialog, select the ISDN-Controller “AVMC2”
and press “Return”.
9. Then enter your parameters:
– PCI slot (number of the PCI slot in which the ISDN-
Controller C2 hardware has been installed; for more
information, see your PC manual)
– Switch Type (D-channel protocol)
– Line Config (MTP = multipoint or PPT = point-to-
point) for each S
0
line
10. Exit the configuration dialog by pressing “Esc” and se-
lect “Yes” to confirm that you want to save the new set-
tings.
11. The final step in the configuration process is to update
the system and load the ISDN-Controller C2. In the “In-
ternetworking Configuration” window, select the “Reini-
tialize System” command and confirm it by selecting
“Yes”.
12. After the system is re-initialized, the system console re-
appears. Press “Alt+Esc” or “Alt+Crtl” to return to the
“Internetworking Configuration” window.
13. Exit the configuration by pressing “Esc”.
The ISDN-Controller C2 is now configured for CAPI Manager
and loaded.
c2-e.book Seite 28 Mittwoch, 27. November 2002 3:24 15