Operation Manual

Loading the Driver Software
26 ISDN-Controller C2 – 6 Installing the Driver Software in Novell NetWare
The configuration dialog that appears shows the cur-
rent settings of the ISDN-Controller C2 and its S
0
lines.
4. Move the selection to the entry you want to change and
press “Return”.
5. Select the new value for the given parameter and con-
firm with “Return”.
6. Repeat steps 4 and 5 until all of the settings are correct.
7. Close the configuration program by pressing the “Esc”
key twice.
8. Answer “Yes” to save your settings.
This concludes the configuration.
Loading the Driver Software
The ISDN-Controller C2 cannot be used until the driver soft-
ware is loaded. The driver software can be loaded either au-
tomatically or manually.
Automatic Loading
The SYS:\SYSTEM folder contains the AUTOEXEC.NCF file.
Add the following entry to this file:
load capi20
Now the driver software will be loaded every time the Net-
Ware Server is started.
Configuration of Controller-2: AVM C2 PCI
I/O Base d400
Interrupt Level 7
D-channel Protocol DSS1
S
0
Port 1 Point to Point: yes
S
0
Port 2 Point to Point: yes
Data Compression no
c2-e.book Seite 26 Mittwoch, 27. November 2002 3:24 15