Operation Manual

Configuring the ISDN-Controller C2
ISDN-Controller C2 – 6 Installing the Driver Software in Novell NetWare 25
The files for the AVM ISDN-Controller C2 are now copied
to the SYS:SYSTEM directory.
9. At the end of the installation process, the file
C2 README for the AVM ISDN-Controller C2 is dis-
played.
Press “ESC” to close the display and confirm by select-
ing “Yes”.
10. Press “Esc” as often as necessary to close all sub-
menus and return to the “Configuration Options” menu.
11. Select “Exit” to close the configuration program.
Once the ISDN-Controller C2 has been installed, it must be
configured before it is ready for operation. Follow the config-
uration instructions in the following section.
6.3 Configuring the ISDN-Controller C2
The ISDN-Controller C2 configuration consists of setting the
D-channel protocol and the line types for each S
0
line.
Configuration of Novell NetWare with Stand-
Alone CAPI
1. Enter the following command at the system console:
load c2setup
2. The “List of ISDN-Controllers to load” shows the avail-
able ISDN-Controllers with their settings for I/O ad-
dress, interrupt, D-channel protocol and PCI slot.
3. Use the arrow keys to select the ISDN-Controller C2
which was just installed and press “Return”.
c2-e.book Seite 25 Mittwoch, 27. November 2002 3:24 15